Tibbo EM100 - Ethernet to Serial Converter Module

10 Base-T Ethernet to Serial Module

The EM100 is Tibbo\'s original 10BaseT Ethernet-to-serial Module for onboard installation.

The EM100 has on-board magnetics and only requires one external component - an RJ45 ethernet connector. EM100 has the lowest power consumption of all Tibbo ethernet modules.

The EM100 is fully sealed (potted) for maximum environmental protection.

Economical pricing makes the Module an ideal choice for low-cost applications.

Tibbo EM100 - Hardware

  • 10BaseT Ethernet port with built-in magnetics.
  • CMOS serial port (TX, RX, RTS, CTS, DTR, and DSR lines).
  • Two additional I/O lines.
  • Four control lines for status LEDs.
  • Power: 40mA @ 5V.
  • Dimensions: 46x28x13mm.
  • Fully sealed (potted) design.
  • Firmware is upgradeable through the serial port or network.

Tibbo EM100 - Functionality

  • Full and half-duplex serial port modes.
  • Server, client, and server/client network (\"routing\") modes
  • Numerous other options for connections, serial port, etc
  • Configuration stored in the EEPROM.
  • Detailed status indication via external LEDs.
  • Setup through the serial port or network (UDP commands).
  • Remote control of all I/O lines including RTS, CTS, DTR, and DSR.
  • \"On-the-fly\" commands for immediate serial port configuration.
  • Serial-side \"modem\" commands for network connections control.
  • Direct control of ADSL modems.
  • Supports UDP, TCP, ARP, ICMP (ping), DHCP, PPPoE, LCP.

Key Features

  • 10baseT Ethernet
  • One CMOS serial port
  • Two I/O lines
  • Built-in magnetics
  • Low power - 40mA@5v
  • Sealed (potted)